Operation Manual

SNMP
208 ViewCast
Configuring SNMP agent contact and location (optional)
After community names, permitted SNMP managers and trap destinations are configured, you may
configure the contact and location information for the associated SNMP agent.
To configure SNMP Agent contact and location:
1.
Run Windows service management tool services.msc
2.
Right click on SNMP Service then click on Properties.
3.
Click on the Agent tab.
4.
Enter appropriate Contact and Location information.
Notes: You may retrieve the system contact information through SNMP query on
.iso.org.dod.internet.mgmt.mib-2.system.sysContact as defined in RFC1213-MIB.
You may retrieve the system location information through SNMP query on
.iso.org.dod.internet.mgmt.mib-2.system.sysLocation as defined in RFC1213-
MIB.
Figure 247. Agent tab