Operation Manual

GoStream Series User Guide
ViewCast 23
Performing the initial startup
The steps in the following table refer to a direct connection to the GoStream series systems only.
To perform the initial startup:
1.
Ensure that you connect all devices (power cords, cables, audio/video sources, etc.) to the
system.
2.
Press Power on the front panel to start the GoStream system. The LCD readout displays the
initializing messages (Figure 7).
Figure 7. Initializing messages
After the system powers up for the first time, the Welcome message appears:
Note: The serial number can be in the format GN00000000.
3.
Press Enter. The system prompts you to set the date (Figure 8).
Figure 8. Date screen
4.
Press Enter to accept the date displayed.
5.
To enter a different date, use the Up and Down arrow buttons to change the numerical value
of the month.
6.
Press Stream to enter the value and move to the Day field.
7.
Use the Up and Down arrow buttons to increment the numerical value of the day.
8.
Press Stream to enter the value and move to the Year field.
9.
Use the Up and Down arrow buttons to increment the numerical value of the year.
10.
Note: If you want to change a previous setting, continue pressing Stream until the cursor
cycles around to the desired field.
11.
Press Enter to accept the settings and move to the next screen to set the system clock (Figure
9). The system uses a 24-hour clock format for its system clock entries.
Figure 9. Time screen
12.
Use the Up and Down arrow buttons to increment the numerical value of the hour.