Operation Manual

Easy Setup
26 ViewCastMicrosoft
Note: Once you modify the setting, the system saves the changes until you modify the
settings again or until you restore the system back to its original factory settings.
10.
Press the Up and Down arrow buttons to select DHCP On/Off.
11.
Press Enter. The enable DHCP screen displays (Figure 17).
Figure 17. Enable DHCP screen
12.
Press the Up and Down arrow buttons to select Yes.
13.
Press Enter. The confirmation screen displays (Figure 18).
Figure 18. Confirmation screen
14.
Press the Up and Down arrow button to select Yes.
15.
Press Enter. The network settings screen displays.
16.
Press the Up and Down arrow buttons to select the IP address.
17.
Press Enter. The IP address screen appears (Figure 19).
Figure 19. IP address screen
18.
Press the Up and Down arrow buttons to change the numeric value.
19.
Press Stream to move to the next field.
20.
Press Enter. The subnet address screen displays (Figure 20).
Figure 20. Subnet address screen
21.
Press the Up and Down arrow buttons to change the numeric value.
22.
Press Enter. The network settings screen displays.
Note: To remove a static IP and/or Gateway address, follow steps 11 through 14 to
enable DHCP. The system removes any previously entered static address.
23.
Press the Up and Down arrow buttons to select Gateway.