Operation Manual

GoStream Series User Guide

ViewCast 61

Drag the sliders to adjust the Brightness, Contrast, Hue, and Saturation (Figure 76).

Figure 76. Video Filter Settings

Note: Click Restore to the right of the filter to reset the settings to the default.

Click the De-Interlace setting you want to apply (Figure 77). Options include:

 None

– Performs no de-interlacing of any kind.

 Bob0

– Applies inverse telecine de-interlacing to all telecine video.

– Applies motion adaptive de-interlacing to all video that is not telecine.

– Switches dynamically between the two modes as the content changes.

– Available for NTSC video only.

 Bob1

– Drops the redundant fields and reassembles the video in a 24 fps progressive format.

– Applies inverse telecine de-interlacing to all telecine video.

– Performs no de-interlacing of video that is not telecine.

– Available for NTSC video only.

 Advanced

– Is an algorithm for de-interlacing pure video (non-telecine) content.

– Applies motion adaptive interlacing to all video. It detects which portions of the image

are still and which portions are in motion then applies different processing to each

scenario.

Figure 77. De-Interlace settings

Note: Telecine and inverse telecine only apply to NTSC video. They are not used for PAL

and SECAM video. The system disables Bob0 and Bob1 choices when you connect the

PAL or SECAM video standard.

Select Add Statistics to overlay video statistics within the video stream for diagnostic

purposes.

Select Embed Timecode to enable embed system time as timecode. This action tags

individual video frames with timecode data. This feature should be used if embedded

timecode is required but your capture device cannot generate it.

10.

Specify the Frame Interval at which timecode should be embedded into the video stream in