Installation Guide

A) For mounting on drywall ceilings:

1) Lift fixture housing to the ceiling, positioning

the center knockout of the housing over

the junction box and parallel to the ceiling.

See Diagram 1.

2) Mark ceiling with a pencil for the drill hole

locations throuth the narrow portion on the 4

keyhole slots. See Diagram 2, 3.

3) Drill 1/8" pilot hole at each location.

4) If drill encounters ceiling joist, use wood

screws ( provided ) & washers ( not

included ) to secure fixture housing to the

ceiling. See diagram 4.

5) If drill DOES NOT ENCOUNTER CEILING

JOIST, use 4 toggle bolts and washers

( both not included ). Enlarge the pilot drill

hole size large enough to accommodate

the toggle bolts tighten and secure fixture

housing to ceiling. See Diagram 5.

6) Reinforce the mounting of the housing to the

ceiling by adding a board between the

expansion part of the toggle bolt and the

ceiling tile. See Diagram 6.

MOUNTING OF THE LIGHT FIXTURE

SAFETY TIP

Diagram 2

iagram 3

Diagram 4

Diagram 5

Diagram 6

Diagram 1

INSTALLATION INSTRUCTIONS

NOTE:

This fixture is designed to be surfaced mounted on a drywall ceiling. Mounting

hardware requirements will depend on mounting method.