Installation Guide

WARNING: Before wiring to the power supply, turn off the electricity at fuse or circuit breaker
box. Ensure grounding to avoid potential electrical shock and to ensure reliable lamp starting.
1) C
onnect the black supply ( line ) wire to the
black wire from the light fixture. Secure the
connection by inserting into the wirenut,
then revolving until secure.Diagram 1.
2) Connect the white supply ( Neutral ) wire to the
white wire from the light fixture. Secure the
connection by inserting into the wirenut,
then revolving until secure.Diagram 1.
CHECK TO MAKE SURE NO BARE WIRES
ARE EXPOSED OUTSIDE THE WIRENUTS.
3) To ground the fixture, connect the bare or green
supply ( Grd ) wire to the green wire comes
with the fixture by inserting into the wirenut,
then revolving until secure. Diagram 1.
3a) Connect dimming control wires to those driver:
Grey to Grey and purple to purple using appropriate
wiring connections. Cap off purple and grey dimming wires
seperately if not in use. Diagram 1.
IF THE HOUSE WIRING DOES NOT HAVE
A GROUND WIRE, CONSULT YOUR LOCAL
ELECTRIC CODE FOR APPROVED METHOD.
4) Replace the wireway cover by reversing the
steps as described on page 2, point 2. See
Diagram 2.
THE FIXTURE SHOULD NOT BE OPERATED
WITHOUT THE WIREWAY COVER IN PLACE.
5) Replace the lens by reversing the steps as
described on page 2, point #1. See
Diagram 3.
BE EXTREMELY CAREFUL WHEN REPLACING
THE LENS BACK ON THE LIGHT FIXTURE TO
AVOID POSSIBLE DAMAGE TO THE LENS.
INSTALLATION INSTRUCTIONS
WIRING OF THE LIGHT FIXTURE
Diagram 2
Di
agram 3
Diagram1