Installation Guide
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 15, 2020 5:06 PM rev 1.0
T6CS LED TROFFER
INSTALLATION INSTRUCTIONS
To reduce the risk of death, personal injury or property, damage from re, electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the xture box and all xture labels.
Commercial installation, service and maintenance of luminaires should be performed by a qualied licensed electrician.
DO NOT INSTALL DAMAGED PRODUCT
WARNING: RISK OF ELECTRIC SHOCK
• Turn o the electrical power at fuse or circuit breaker box before wiring xture to power supply.
• Turn o the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electric Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from cartons, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packaging material, as these may be hazardous to children.
• Ensure xtures are properly secured to T-bar grid and/or ceiling using wire or aircraft cable capable of supporting 100lbs minimum.
CAUTION: RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS
What’s In The Box
One (1) T6CS
LED Troer
Tools Needed
This LED Troer requires very few tools for installation.
A drill or a screwdriver and a pair of wirecutter.
Installation
1
2
Preparation
• Shut o power to desired circuit before any work.
Identify and prepare location for installation.
• Carefully unpack the xture from its packaging and
inspect product for defects due to shipping.
• Bend the four mounting/grid-tie clips up and out from
the xture.
Mounting
• Place xture into t-grid ceiling.
• Secure safety cable through hole in grid-tie clips per
local seismic codes.
Safety cable hole