Installation Guide

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 9, 2018 8:20 AM rev 1.0
TPC LED TROFFER
INSTALLATION INSTRUCTIONS
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US
or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until xture has cooled down before installing or servicing the xture.
MIN. 90°C SUPPLY CONDUCTORS
What’s In The Box Tools Needed
One (1) TPC Edgelit LED Troer
Wire Nuts
This Edgelit LED Troer requires very few tools for installation. A
drill or a screwdriver and a pair of wirecutter. Sheet metal screws
can be used to attach the xture to the T-grid or framing.
Carefully unpack the xture from its packaging. Inspect product
for defects due to shipping.
Locate desired positioning for xture in ceiling grid. Remove ceiling
tiles if necessary.
1
2
4
Bend grid mounting tabs.
Turn o power to appropriate
circuit at the breaker panel.
3