Assembly Instruction

i
Hardware in this box.
2
3
Page 1 of 1
Assembly
Instructions
1
Packed in this box.
Instructions for Bifold Body assembly, are packed in the BODY box.
i
BODY INSTRUCTIONS: Instructions for assembly of
arms to the Wood Futon Body are in the BODY box.
Contrary to Assembly Instructions in the BODY box, You will
need to join both the Back Deck and the Seat Deck together,
as shown, before fitting them between the Arms.
!
4
Fasten Stretcher Brackets to Arm.
Attach Magazine Racks to Arms.
Hilton-0404
See below for
Preparation of arms
for assembly.
SPECIAL NOTE: Back and Seat Assembly.
5
Assemble the Wood Futon Body.
Using the 30mm
Bolts,fix the Magazine
Rack to the Arm.
6
Fit Wood Buttons into Arm Holes.
AFTER TOTAL ASSEMBLY:
Push fit or lightly tap
the wooden buttons
into the bolt holes
on the arms.
Tighten the bolts.
BIFOLD FUTON FRAME
FUTON ARMS
Arm - Inside ViewArm - Outside View Magazine Racks x 2 Pieces
Stretcher
Brackets x 4
Allen Key x 1
100mm Bolts x 8
30mm Bolts x 8
16mm Bolts x 4
Barrel Nuts x 8
Wood Dowels x 4
Wood Button
x 8
30mm Bolts
Magazine
Rack
30mm
Bolts
Insert the Stretcher Bracket Cleat into the hole provided.
IMPORTANT: Don't fully tighten Bracket until the
Stretchers are all in place for easy alignment.
Each arm requires two brackets, front and back.C.
B.
A.
Cleat
Stretcher
Bracket
16mm Bolt
Hole for
cleat
Leg
Dowel
Hole
Hole for
bolt
Dowel from
ARM box
Stretcher Rail
from BODY box
NOTE: Fitting
Wooden Dowels
Tap Wood Dowel all the way into the
middle hole before assembly to arm.
Clevis Pin