Full Product Manual

12
Perform the following steps to get the rest of the hardware setup!
1. Connect the two antennas to the antenna
ports on the rear of the recorder.
4. Connect the WNVR power adapter to the
Power Input on the rear of the WNVR.
2. Plug one end of the included Ethernet cable
into the LAN port on the back of the WNVR.
NOTE: Night Owl recommends
connecting to the Internet for
the best user experience.
3. Plug the other end of the Ethernet cable into
a port on the back of your router / network
access point.
NOTE: As long as your WNVR is
hardwired using Ethernet
cabling, you can connect to any
working network access point.
See your product manual for
RESET
LAN1 LAN2 LAN3 LAN4 WAN


5. Plug the WNVR power adapter into a surge
protector or Uninterruptible Power Supply

NOTE: Make sure the UPS or surge
protector is switched ON.

