Installation Guide

3
Connect the DVR power adapter
to the Power Input on the rear
of the DVR.
10
Connect the red female power
leads of the video/power cables
to the male power splitter ends.
8
NOTE: Check that the UPS or surge protector
is switched ON.
Power
Splitter
Camera Power
Adapter
(Surge
Protector Not
Included)
Power Cable
Connectors
Power Splitter
Connectors
Connect the power splitter to the
camera power adapter and plug the
adapter into a surge protector or
Uninterruptible Power Supply (UPS).
9
NOTE: Some systems will beep upon booting up.
Plug the DVR power adapter into a
surge protector or Uninterruptible
Power Supply (UPS).
11
(Surge
Protector Not
included)
NOTE: Audio enabled cameras will have
a white RCA connector to transmit audio
signal (Optional).
FROM Camera TO Camera
Connect the ends of the cable
attached to the camera to the
ends of a video/power cable
labeled TO CAMERA ONLY.
6
NOTE: Make sure you twist and lock BNC connectors.
Connect the BNC connector of the
video/power cable labeled TO DVR
ONLY to an open video input on
the DVR.
7