Operation Manual

TIRE AND LOADING INFORMATION
LABEL
The cold tire pressure is shown on the Tire and
Loading Information Label. The label is located as
shown.
AIR CONDITIONER SPECIFICATION
LABEL
The air conditioner specification label is affixed to
the underside of the hood as shown.
Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 5 mm
(0.20 in) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
2. Mount license plate
䊊
1
using two M6-
14mm bolts.
License plate bolt tightening torque:
5.74 N·m (4.0 ft-lb)
WTI0174 WTI0178 LTI2123
INSTALLING FRONT LICENSE PLATE
Technical and consumer information 9-13