Instructions / Assembly
Step 2
Step 3
2.1)Drill two holes on the wall at the same height as the Restraint Straps(⑧) on the
Table using a Power Drill(⑨).
You can mark this point in two ways as below:
1) Move theTable back to the wall. Mark two points the same height as the Table on the
wall.
Note: The Restraint Straps need to be secured to a solid, load bearing surface.
Please use a Stud Finder(not supplied) if needed to locate the Wall Frame.
2) Measure the height of the Restraint Strap(⑧)with a ruler/measuring tape and mark on
the wall to keep them accurate and at the same height.
2.2) Attach Wall Anchors (⑦) to the holes on the wall using a Hammer(⑩).
Attach the Restraint Straps(⑧) to the Wall Anchor (⑦) using Screws(⑤) and the Power
Drill(⑨)
Your Table is ready for use.
Caution: This Table can only be used on a flat, level surface.
2.1
2.2
8
5
Noble house Home Furnishings LLC Page 7 OF Page 8