Use and Care Manual

Step 5
Place Table top (A) with its underside skywards onto a clean, soft surface
to avoid any scratch or damage to the product.
Position Leg Frame in step 4 onto Table Top (A)
Using two Short Bolts ( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.1) ① ②
⑥
Allen Key ( ) to connect middle support bar of Table Top (A) and Leg Frame (B & C).
⑤
Using two Short Bolts( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.2) ① ②
⑥
Allen Key ( ) to connect side support bar of Table Top (A) and Leg Frame (B & C).
⑤
Do not fully tighten the Bolts.
Step 6
With assistance from your adult partners, turn the Table back to normal flat
ground
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Screws and Bolts until evenly
secured.
Inspect the Table and make sure all parts are adequately connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
LEVELER
STEP 5.1 STEP 5.2