Caution :You must read this before you proceed Club Chair 1 of 5
Label Description QTY A Chair 1 B Wooden Leg 4 Description QTY Washer Rings 7 pcs Label Picture Picture C Before Beginning Assembly: 2 of 5
Step 1 Position the chair on its back,as shown. Unzip to open pouch and remove the 4 wooden legs, close the pouch. Step 2 Install leg into the chair by putting a Washer Ring (optional )on the threaded stem and then insert the threaded stem into the threaded hole at each corner of the bottom of the chair. Tighten by turning leg clockwise. Repeat the same Step to install the other three legs. When assembling the Legs, the two BEVELLED Slant-Angled face of wooden leg must be affixed to be inwards facing.
Step 3 Make sure all parts are connected and locked into position. Your chair is ready for use.
of 5