Use and Care Manual

ManualsBrandsNoble House ManualsOutdoorsKyree Shiny Copper Rectangular Cast Aluminum Outdoor Dining Table

CAUTION : This table is NOT a TOY.

Keep your child / children at bay in the process of assembly.

Assembly Instructions

Table

Warnings: You must read this before you proceed.

REMINDER : In the event of unsuitability and you intend to return, please disassemble

by reversing the assembly process and where possible pack to fit into itsORIGINAL

CARTON BOX.

Summary of content (5 pages)

PAGE 1
Assembly Instructions Warnings: You must read this before you proceed. REMINDER : In the event of unsuitability and you intend to return, please disassemble by reversing the assembly process and where possible pack to fit into itsORIGINAL CARTON BOX. Table CAUTION : This table is NOT a TOY. Keep your child / children at bay in the process of assembly.
PAGE 2
No. Description Qty A Table top 1 B Legs Support Panels (Long side) 2 C Legs Support Panels (Short side) 2 D Table Legs 4 Description Qty E Screws (M8*40MM) 13 F Nuts 13 G Springs Washers 13 H Flat Washers 13 I Spanners 1 J Screwdriver 1 K Leg Levellers(Pre-attached) 5 No.
PAGE 3
Step 1 Unpack all parts. To avoid any scratch and or damage to the products, place onto a clean flat soft surface. To the underside of the table, there are 4 (four) assembly points. Insert Screws E into these 4 (four) positions with screwdriver(J). To the legs, there are 2 (two) assembly points on each leg. Insert Screws E into these 8 locations for all 4 (four) legs with screwdriver(J). TIGHTEN ALL THE SCREWs. Step 2 G H E Attach the legs to the table top.
PAGE 4
Step 3 1# 2# This next step is to assemble the leg panels to the table legs. Attach the Legs Support Panel with 1# end to the Screws on the Legs, and then attach the Legs Support Panel with 2# end. Partially tighten Nuts with Flat Washers(H)+Spring Washers(G)+Nuts(F) to the screws. Repeat the same process for all contact points of the Table Legs and the Legs Support Panels. Once all the Leg Support Panels are in place, tighten all nuts in a sequential manner. Step 4 K Turn the table right side up.
PAGE 5