Caution : You must read this before you proceed Club Chair Label Picture Description QTY A1 Chair Back 1 A2 Chair Base 1 Noble House Home Furnishings LLC Page 1 OF 5
B1 Front Leg 2 B2 Back Leg 2 Description QTY Gasket 7 Label Picture ① Noble House Home Furnishings LLC Page 2 OF 5
Chair Back (A1) Chair Base (A2) Front Leg (B1) FRONT FACING This Club Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Place the Chair on its back on a clean, non-marring surface as pictured above.
Step 3 A1 A2 If you find a gap between the Chair Back(A1) and Chair Base(A2), please push rock the Chair Back(A1) back and forth slightly, while pressing the Chair Back downwards until the gap disappeares. Step 4 Install Front Leg(B1) into the Chair Base(A2) by putting a Gasket(①) on the threaded stem. Then insert the threaded stem into the mounting position at the corner of the bottom of Chair Base(A2). Tighten by turning the Front Leg(B1) clockwise by hand.
Noble House Home Furnishings LLC Page 5 OF 5