Caution: You must read this before you proceed Loveseat Label Picture Description QTY A Right Armrest 1 B Left Armrest 1 C Chair Seat 1 D Chair Back 1 E Back Cushion 2 F Seat Cushion 2 1 OF 8
Label Picture Description QTY ➀ Allen Key 1 ➁ Bolt (M6*30mm) Bolt (M6*40mm) Bolt (M6*95mm) ➂ ➃ 7 8 3 ➄ Washer 16 ➅ PE Cap 3 Before Beginning Assembly: 2 OF 8
OVERVIEW Back Cushion(E) Left Armrest(B) Chair Back(D) Right Armrest(A) Chair Seat(C) Seat Cushion (F) FRONT FACING This Loveseat has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Loveseat parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Open the carton and place all the parts onto a clean, non-marring surface. Hold the Chair Seat (C )up and align the mounting positions to the Left Armrest(B) . Step(1-1) Attach Chair Seat(C) to Left Armrest(B) using Bolt(➁) and Washer(➄) with Allen Key(➀). Step(1-2) Attach Chair Seat(C) to Left Armrest(B) using Bolt(➂) and Washer(➄) with Allen Key(➀). Only loosely tighten the Bolts. ATTENTION: There may be some PE wicker that may have covered the Bolt points.
Step 3 Place the Loveseat as shown in the picture above. Align the mounting positions of the Left Armrest(B) onto the Chair Back(D). Attach Left Armrest(B) and Chair Back(D) using Bolt(➃) and Washer(➄) with Allen Key(➀). Only loosely tighten the Bolts.
Step4-6,7) Attach Right Armrest(A) to the Right Armrest(B) and Chair Back(D) using Bolt(➂) and Washer(➄) with Allen Key(➀). Step4-8,9,10) Attach Right Armrest(A) to the Right Armrest(B) and Chair Back(D) using Bolt(➁) and Washer(➄) with Allen Key(➀). Only loosely tighten the Bolts. Step 5 Place the Loveseat as shown in the picture above. Align the mounting positions of the Right Armrest(A) onto the Chair Back(D). Attach Right Armrest(A) and Chair Back(D) using Bolt(➃) and Washer(➄) with Allen Key(➀).
Turn the Loveseat right side up. Place the Loveseat on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently sit on the Loveseat. This will help to align all parts at all joints. Then carefully get off the Loveseat, and in a sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. This may cause the frame to warp.
OF 8