Caution : You must read this before you proceed Table Label Description QTY A Table Top 1 B Leg 4 Description Washer Bolt (M6*15) QTY 17 17 Allen Key 1 Label ① ② Picture Picture ③ Before Beginning Assembly: *17 *17 Page 1 OF 4
Overview Table Top(A) Note: The point of the Legs corners should match with the Table Edges Leg(B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 3 Place the Table on a LEVEL SURFACE to check for wobbles. If it wobbles, apply even steady pressure down on the Table. This action should help align all parts. Then proceed to tighten all Bolts at all joints Do NOT fully tighten a Bolt in one go and then move on to the next one. Rather, in a sequential manner, gradually tighten each Bolt until all Bolts are evenly secured. This methodology will ensure maximum evenness once all Bolts are fully tightened. Step 4 Your Table is ready for use.
Page 4 OF 4