User Manual

make any connections to the carburetor, fuel lines, or

thin, sheet metal parts. The below instructions are for a

negative ground system (most common). If your vehicle is a

positive ground system (very uncommon), follow the below

instructions in reverse order.

1.) Connect the positive (red) battery clamp or eyelet

terminal connector to the positive (POS,P,+) battery

terminal.

2.) Connect the negative (black) battery clamp or eyelet

terminal connector to the negative (NEG,N,-) battery

terminal or vehicle chassis.

3.) Connect the battery charger’s AC power plug into a

suitable electrical outlet. Do not face the battery when

making this connection.

4.) When disconnecting the battery charger, disconnect

in the reverse sequence, removing the negative ﬁrst (or

positive ﬁrst for positive ground systems).

Begin Charging.

1.) Verify the voltage and chemistry of the battery.

2.) Conﬁrm that you have connected the battery clamps or

eyelet terminal connectors properly and the AC power plug

is plugged into an electrical outlet.

3.) The charger will begin in Standby mode, indicated by

an orange LED. In Standby, the charger is not providing

any power.

4.) Press the mode button to toggle to the appropriate

charge mode (press and hold for three seconds to enter an

advanced charge mode) for the voltage and chemistry of

your battery.

5.) The mode LED will illuminate the selected charge mode

and the Charge LEDs will illuminate (depending on the

health of the battery) indicating the charging process has

started.

6.) The charger can now be left connected to the battery at

all times to provide maintenance charging.