Installation Guide
Table Of Contents
5
Wiring
After mounting the Control Unit into the Housing, please wire the electrical connections before
powering the Control Unit. The attached schematic, in the following pages, would provide
helpful information.
- Blue and Brown wires from power cable connect with GND and +12v -to- +24v from the
power supply, respectively.
- Within the other cable, Black wire is ground reference.
- Red goes to the Red of the Door strike. Black from the Door strike connects with
grounds.
- If the Exit button and/or Door position sensor are applicable:
Green goes to one terminal of the Exit button and the other terminal is grounded.
White goes to one wire of the door sensor and the other wire is grounded.