Installation Guide
Table Of Contents
3
Mounting the Housing Assembly
The housing should be mounted onto the desired
dry-wall or sheet metal structure, as shown in the
overview photograph.
- Drill a hole of 57 mm. or 2 ¼ in. into the desired
structure on which you would want to mount
the device.
- Unscrew the housing fastener.
- Remove the plastic tape cover on the back of
the housing to expose the adhesive surface.
- Please make sure the hole to run the cables
should point left or right and NOT up or down.
This orientation is required for the motion
sensors to work as desired.
- After making sure the housing is oriented
correctly, as shown in the figure to the right,
screw the fastener back onto the housing and
let the adhesive stick to the mounting surface.
Connecting the cable
There is just one cables which is provided with Control
Unit. It drives the electronic door stick and reads from the
sensors/buttons (if applicable).
Please run the cable thru the slot in the housing and
connect the cable to its corresponding port on the Control
Unit’s circuit board which can be see on it’s underside, as
shown in the figure to the left.
The cable mate with the black port in the center, with 4
female pins. This cable has 4 wires.