Installation Guide
Table Of Contents
3
Mounting the Housing Assembly
The housing should be mounted onto the desired dry-wall or sheet metal structure, as shown in
the overview photograph.
- Drill a hole of 57 mm. or 2 ¼ in. into the
desired structure on which you would
want to mount the device.
- Unscrew the housing fastener.
- Remove the plastic tape cover on the back
of the housing to expose the adhesive
surface.
- Please make sure the hole to run the
cables should point left or right and NOT
up or down. This orientation is required
for the motion sensors to work as desired.
- After making sure the housing is oriented
correctly, as shown in the figure to the
right, screw the fastener back onto the
housing and let the adhesive stick to the
mounting surface.
Connecting the cables
There are two cables which are provided with Control Unit.
One of them is to power the Control Unit and the other is to
drive the electronic door stick and read from the
sensors/buttons (if applicable).
Please run the cables thru the slot in the housing and connect
the cables to their corresponding ports on the Control Unit’s
circuit board which can be see on it’s underside, as shown in
the figure to the right.