User Manual

12
6 Again, note how many lights are blinking while the RSU is in this
orientation. The stronger the signal, the more lights on the RSU
blink.
7 Point the front of the RSU to the left of the starting position.
Remove your hands from the RSU, and let it stand still for about
5 seconds. Note how many lights blink while the RSU is in this
orientation.
8 Remembering the strongest signal reported, re-orient the front of
the RSU in the direction that the RSU was pointed when the
strongest signal was found.
9 Plug the Ethernet cable into your computer. The other end of the
cable should already be plugged into the RSU.
10 Turn on your computer. During power up, the lights on the RSU
stop blinking, and are continuously lit.
11 After the lights stop blinking, observe the lights for about 30 to
90 seconds. Make sure the same number (or more) of indicator
lights stay on.
• If the same number or more lights are on, you are ready to
use your high-speed Internet connection.
• If fewer lights are on, complete the fine tuning steps de-
scribed in the section, “Fine-tuning the connection to the ser-
vice provider” on page 16.