User Manual

22
If your Internet browser cannot open any sites:
1 Make sure your computer is set up to automatically receive an IP
address, as described in the section, “Setting up the computer to
dynamically receive an IP address” on page 4.
2 Refresh the connection with your service provider by performing
one of the following:
• If you are a Windows user, open the Link Monitor program.
Click the Renew IP Address button.
• If you are using a non-Windows operating system, reboot
your computer.
3 Try opening a few web sites with your Internet browser.
THE LIGHTS ON THE RSU BLINK MORE SLOWLY
THAN NORMAL
When your RSU searches for a service provider signal, the lights on
the RSU blink on and off rapidly. If you notice the RSU’s lights
blinking more slowly than usual, this usually indicates that your RSU
is trying to register with your service provider.
During registration, your service provider may be checking records to
indicate that you are a valid user of the service provider’s system. In
most cases, the registration process happens so quickly you hardly
notice a change in the blink rate of the lights on your RSU.
However, if the lights blink slowly for an extended time (more than
30 seconds):
1 Unplug the Ethernet cable from the bottom of the RSU.
2 Repeat the procedure described in the section “Using the
indicator lights to find the strongest service provider signal” on
page 10.
At the end of this procedure, you should have plugged the
Ethernet cable back in.
3 Perform one of the following:
• If your RSU successfully registers, as indicated by continu-
ously lit lights, you can use your connection.
• If the lights on your RSU continue to slowly blink on and off,
contact your service provider.