User Manual
1
Welcome
This document describes how to install and use your Expedience
residential subscriber unit (RSU) to obtain wireless high-speed
Internet access. You can connect your RSU to a computer or to a
small office/home office (SOHO) local area network (LAN) through
a hub, switch, or router.
BEFORE YOU BEGIN
• Make sure your computer is equipped with an Ethernet network
interface card (NIC).
• The Ethernet cable that is supplied with your RSU plugs into
any standard Ethernet NIC. The NIC is not provided with
the RSU, but you can purchase a NIC at most computer and
electronics stores.
• Find an appropriate location for your RSU.
• Make sure you are operating the RSU in a room near an out-
side window on the first or second floor of your home or
office.
• You need to locate the RSU close to a wall outlet. The RSU
uses a standard power supply and can sit on a desktop or
shelf.
• Your RSU comes with a category-5 Ethernet cable. If you
choose to place the RSU a good distance from your comput-
er, you may need to purchase a longer Ethernet cable.
If you purchase a cable, make sure the cable is a category-5
Ethernet cable with RJ-45 connectors on each end.
Make sure the longer cable that you might purchase is flexi-
ble enough to bend under the bottom of the RSU.
• Locate the components shipped with your RSU device:
•RSU device
•Software CD-ROM
• RSU Installation Guide and Quick Start Guide
• Power cable and power supply box
• Ethernet cable