Instruction Manual

Place the second panel in position next to the first floor panel but

DO NOT LOCK!

Shim the second panel, where necessary, using the same procedure

as was used on the first panel. When all four edges of the second

floor panel are properly shimmed, lock the two panels securely

together. Using the same technique for leveling, check the levelness

of the two sections in all directions by placing the level across the

joint at several points and, again, check the levelness of the floor

panels in the direction of the panel joint.

Refer to the erection diagram and install the remainder of the floor

panels using the same procedure as was used for the first and

second floor panels. When all of the floor panels are installed and

leveled perfectly, check the section latches for full and complete

locking.

Trim excess vapor barrier.

flooR insTallaTion (shim levelinG meThod)