Instruction Manual

WALK-IN INSTALLATION

Wall & Ceiling Panel Erection

The installation instructions that follow apply to any walk-in cooler or

freezer where the wall panels are supported either by foamed walk-in

floor panels or by a floor sealer (screed) assembly which has been

accurately located and properly leveled. NOTE: The procedure for

erecting wall and ceiling panels will be identical in all cases. NOTE:

The walls do not lock to vinyl sealers, but will lock to foam sealers when

used.

To aid in the erection process, the floor plan furnished with your walk-in

has part numbers listed for each wall, corner, ceiling and floor section.

Match the part number on the floor plan to the label on the interior of

each panel to determine the current placement for each panel.

Notice, also, that the section latch access holes on the vertical edge of

the panel are always on the interior of the panel.

Position the corner panel in the

proper location on the walk-in

floor or vinyl screed assembly

and, IF THE WALK-IN HAS A

FLOOR, flush the corner panel

with the corner of the floor panel

in both directions and lock it

securely to the floor panel.

Walk-in insTallaTion -Wall & ceilinG Panel eRecTion

Select the first panel to be installed,

normally begin with a CORNER PANEL.

Notice that the panel is labeled "Top"

along with a part number indicating that

when the panel is in its proper position,

the labeled end will be up.