Instruction Manual

As each wall panel or corner panel is erected and locked in an

adjoining panel along the vertical joint, engage the section latches to

the floor panels by turning the hex locking wrench ONLY ABOUT 1/4

TURN CLOCKWISE.

Make certain that the wall or corner panel is perfectly aligned with the

floor panel or foamed sealer

before engaging the section

latches.

Continue erecting panels

according to the part numbers shown

on the floor plan, and follow, explicitly,

the technique described for panel

alignment.

CEILING PANELS will be erected at

specific intervals to facilitate the

installation. The intermittent ceiling

panel erection is scheduled to allow the

ceiling panels to serve as supporting

ties between opposite walls as the

installation progresses. CAUTION!

DO NOT SLIDE CEILING PANELS INTO POSITION! To avoid gasket damage,

elevate the ceiling section clear of the wall section while bringing it into position.

When adjoining ceiling panels are in position,

adjust the exterior edges so that they are

perfectly flush with one another and with the

wall panels directly below them. Lock the

ceiling panels securely to each other. DO NO

LOCK ceiling panels to wall panels at this time.

NOTE: If local conditions, such as existing

building walls, make it difficult to align ceiling

panels with each other from the exterior, locate

a step ladder near the interior walls to visually

inspect the alignment and adjust as necessary.

Walk-in insTallaTion -Wall & ceilinG Panel eRecTion