Instruction Manual

Walk-in mainTenance

Sweep GaSket Replacement

1. Determine which sweep gasket your walk-in has:

a. Old sweep gasket held in with screws (go to #2)

b. New style held in by integral dart (go to #5 and skip #6).

2. Remove screws that retain the old style gasket (if no screws

hold in gasket, skip to #5) and remove gasket.

3. With old sweep gasket removed, determine if door gasket

length needs to be cut to accommodate new style door sweep

by placing sweep gasket into position. If the sweep can be

positioned so the dart on the back of the gasket aligns with the

slot in gasket retainer of the door without interference from the

door gasket, proceed to #5 and skip #4 and #6.

4. If door gasket interferes with new floor sweep, pull 6 to 8

inches of the door gasket out from gasket retainer on both

ends of gasket.

5. Install sweep gasket starting at one end, insert dart-shaped

projection into retainer slot and using a rubber mallet, drive

dart into the retainer slot.

6. With sweep gasket in place, mark the length of the door

gasket. Cut door gasket to butt up against the sweep gasket.

Seal the ends of door gasket, if necessary, with silicon.