Instruction Manual

Using small pieces of electrical tape, fasten the heater wire in place. Lift the heater wire at each corner and apply

three thicknesses of electrical tape around the insulation over a length of approximately 3".

Follow by forming a small loop at each corner to permit expansion and

contraction of the heater wire without strain at these points. After the loops

are formed, tape them in place with a short strip of electrical tape.

The heater wire should be relatively straight in the head jamb and in the side

jambs, but all excess heater wire must be taken up in the THRESHOLD AREA

ONLY by forming a "zig-zag" configuration. Make sure that this configuration

will be accommodated by the width of the raceway in the bottom plate or

threshold. The extra length of heater wire concentrated in the threshold will

produce more heat per foot in the threshold than in the jambs.

After the heater wire is in place, tape it down where necessary with short

strips of electrical tape to prevent the heater wire from interfering with the

replacement of the chrome trim.

STAINLESS STEEL TRIM REPLACEMENT

Start replacing the stainless steel trim with the head trim section. Hold in

place while replacing the three screws. Install the right and left trim in a similar manner. The trim should easily

be replaced by hand.

THRESHOLD

REPLACEMENT

Place the threshold in its original

location and replace all of the screws

in their original locations. Reminder:

The hardboard needs to be in place

before replacing the threshold. After

the threshold is secured, apply a

3/16" bead of silicone sealant at both ends of the threshold where they meet the side jambs. With a wet finger,

smooth out the silicone fillet for a neat, professional looking job.

Walk-in mainTenance