Instruction Manual

Walk-in mainTenance

ELECTRICAL CONNECTION

Referring to the wiring diagram in the "Electrical Connections" section of this manual, connect the heater wire leads

as shown. If short lengths of the lead wires were left as indicators, connect the replacement heater leads to those

points of connection and discard the short indicator lengths.

NOTE: If one of the heater leads connects to another wire through a wire connector, obtain a properly sized, twist-

on wire connector for this purpose.

Replace the pilot light and switch in the switch box and attach the switch cover to complete the job. Energize the

walk-in cooler to resume operation.

PANEL CLEANING AND MAINTENANCE RECOMMENDATIONS

During the course of uncrating, handling and installation, the panel surfaces of your walk-in cooler or freezer may

have become stained or dirty. Cleaning all metal type surfaces, door trim and gaskets can be performed with a

mild detergent and hot water. It is important that you remove all excess soap and dry the surfaces

thoroughly. Never, under any circumstances, use an abrasive or alkaline solution.

Occasionally it may become necessary to clean the interior surface for sanitary purposes. A mild solution of baking

soda and warm water will tend to impart a clean, sweet smell to the interior should odors occur from spillage or

container breakage. Never leave standing water inside the walk-in cooler or freezer.