Installation Guide

6505 Gayhart Street, Commerce, CA 90040
Tel [phone] | www.noralighting.com | e-mail: [e-mail]
© 2021 Nora Lighting, Inc. All rights reserved. Instructions subject to change without notice.
042321P1
IS-NTE-870-R01
READ PRIOR TO ATTEMPTING INSTALLATION
ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION
INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN
IMPORTANT - This equipment is intended to be installed only by qualified personnel. The installation must be made in accordance with the current edition of the National Electrical Code and all applicable state and local
building codes. The final installation must be approved by the appropriate, qualified electrical/building inspector(s). Improper installation may result in a fire or electrical hazard. Be sure the electrical power to the circuit has
been disconnected before installing this electrical system.
IMPORTANT - Cet équipement est destiné à être installé uniquement par du personnel qualifié. L’installation doit être faite conformément à l’édition actuelle du Code national de l’électricité et à tous les codes de
construction locaux et nationaux applicables. L’installation finale doit être approuvée par un ou plusieurs inspecteurs qualifiés en électricité / bâtiment. Une installation incorrecte peut entraîner un incendie ou un risque
électrique. Assurez-vous que l’alimentation électrique du circuit a été déconnectée avant d’installer ce système électrique.
NOTE: LED Track Head comes ready to install right out of the box.
1. Twist track head cap counter clockwise to release optic holder. (Figure 1)
2. Push out the optic from the holder. (Figure 2)
3. Insert desired optic into holder.
4. Replace optic holder and twist clockwise to lock.
Figure 1
CHANGING OPTIC
Installation Instructions
NTE-870
MAC LED Track Head
INSTALLATION INSTRUCTION
1. Turn off power to track before begnning installation.
If installing in single circuit track, proceed to step 3.
2. If installing in two circuit track, raise “Circuit Contact” on the track head adapter by using a flathead screwdriver to lift up contact to second circuit. (Figure 1)
3. Align the track head adapter and contacts parallel with track.
4. Insert the adapter into the track and twist the adapter towards the polarity line until the latch locks into track. (Figure 2)
Latch
Polarity Line
Figure 1 Figure 2Single Circuit Two Circuit
Neutral
Polarity Groove Polarity Groove
Ground
One-Circuit
Neutral
Ground
Two-Circuit
One-Circuit
Figure 2 Figure 2
Circuit
Contact