HD5-E HARDI Europe AutoSlant DAH or DAH09 End-User Manual
Printed in Canada Copyright 2012 by NORAC Systems International Inc. Reorder P/N: UC4.5-BC-HD5-INSTE Rev A (HARDI Europe AutoSlant DAH or DAH09 EndUser) NOTICE: NORAC Systems International Inc. reserves the right to improve products and their specifications without notice and without the requirement to update products sold previously. Every effort has been made to ensure the accuracy of the information contained in this manual.
Contents 1 Introduction ................................................................................................................ 1 2 Parts Lists ................................................................................................................... 1 3 Control Panel Installation ......................................................................................... 2 4 Cable Installation ............................................................................................
1 Introduction Congratulations on your purchase of the NORAC UC4.5 Spray Height Control System. This system is manufactured with top quality components and is engineered using the latest technology to provide operating reliability unmatched for years to come. When properly used the system can provide protection from sprayer boom damage, improve sprayer efficiency, and ensure chemicals are applied correctly. Please take the time to read this manual completely before attempting to install the system.
3 Control Panel Installation Install the UC4.5 Control Panel (E01) in the cab of the sprayer with the supplied mounting bracket. The location must facilitate connecting the power cable (C10) to the back of the UC4.5 Control Panel. Using Item M16 together with the adjustable RAM mount on the control panel (E01), mount panel to the HARDI controller bracket. 4 Cable Installation Figure 1: Cable Connections 1. Connect C10 to the UC4.5 Control Panel in the sprayer cab.
5 Calibration 5.1 Initial Power Up 1. Turn on the power for the UC4.5 Control Panel using the switch on the side of its chassis. Ensure that the UC4.5 display lights up to confirm that the panel has +12 volt power. 2. After a moment the panel will display the Main Run Screen: M 5.2 90 M ReTune 1. For optimal performance, the UC4.5 Height Control System must be calibrated to the tractor unit powering the sprayer hydraulics.
5.3 Calibrating the Slant Valve The roll (slant) valve can only be calibrated manually as described below. When calibrating the roll valve, calibrate the deadzone clockwise and counter clockwise settings first and then the gain clockwise and counter clockwise settings. Navigating to the Slant Valve Settings: 1. Ensure the UC4.5 control panel is in manual mode and at the run screen. 2. Press until the display shows "More?". Press 3. Press until the display shows "Roll?". Press to confirm. to confirm.
5. The change in height reading is live as long as the button is held. Wait until the height reading has settled to a stable value and record this reading. 6. Average three readings. The acceptable average change in height should be from 20 to 50 mm. 7. If the average is less, increase the DZ setting with the more, decrease the DZ setting with the buttons. buttons. If the average is 8. Repeat Steps 3 to 7 until the average falls within 20 to 50 mm.
6 UC4.
Canada NORAC Systems International Inc. Phone: (+1) 306 664 6711 Toll Free: 1 800 667 3921 Shipping Address: 3702 Kinnear Place Saskatoon, SK S7P 0A6 United States NORAC, Inc. Phone: (+1) 952 224 4142 Toll Free: 1 866 306 6722 Shipping Address: 6667 West Old Shakopee Road, Suite 111 Bloomington, MN 55438 Europe NORAC Europe Phone: (+33) (0)4 26 47 04 42 Shipping Address: Rue de l’hermitage 01090 GUEREINS France www.norac.
