Operation Manual

18
19. Note: If assembled on a smooth surface, the
treadmill may roll forward during this step.
Raise the Frame (56) to the upright position.
Have a second person hold the Frame until
step 21 is completed.
Remove the two 5/16" x 3/4" Screws (4) from the
Latch Crossbar (38).
Orient the Latch Crossbar (38) as shown. Make
sure that the “This side toward belt” sticker
(J) is facing away from you. Attach the Latch
Crossbar to the brackets on the Frame (56) with
the two 5/16" x 3/4" Screws (4) and two 5/16"
Star Washers (11).
56
38
J
11
11
4
4
Brackets
19
18. Carefully slide the Upright Crossbar (41)
between the Uprights (89, 90). Attach the Upright
Crossbar with the four 5/16" x 3/4" Screws (4)
that you removed in step 6 and four 5/16" Star
Washers (11). Start all four Screws, and then
tighten them.
18
89
4
11
41
90
11
4