Operation Manual

19
21. Align the upper end of the Storage Latch (53)
with the bracket on the Latch Crossbar (38).
Insert a 5/16" x 2 1/4" Bolt (3) through the
bracket. This should push a spacer (L) out of the
other end. Discard the spacer.
Attach the Storage Latch (53) with the 5/16" x 2
1/4" Bolt (3) and a 5/16" Nut (12).
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 30).
20. Orient the Storage Latch (53) so that the decal is
facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (53) to
the bracket on the Base (94) with a 5/16" x 1 3/4"
Bolt (6) and a 5/16" Nut (12).
Raise the Storage Latch (53) to a vertical posi-
tion. Then, remove and discard the tie (K).
38
94
53
6
3
Decal
12
56
12
53
20
21
22. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the fl oor or carpet, place a mat under the treadmill.
Note: Extra parts may be included. Keep the included hex keys in a secure place; one of the hex keys is used
to adjust the walking belt (see pages 32 and 33).
L
K