Operation Manual

MAINTENANCE

Regular maintenance is important for optimal

performance and to reduce wear. Inspect and properly

tighten all parts each time the studio cycle is used.

Replace any worn parts immediately.

To clean the studio cycle, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in and that the power

switch is in the reset position.

If you are having problems connecting the console

to a wireless network or if you are having problems

with your iFit account or iFit workouts, go to

support.iFit.com.

If the Console (10) does not stay in place when it is

moved to the desired position, tighten the indicated M8

Locknut (99) slightly until the Console stays in place.

INCLINE SYSTEM TROUBLESHOOTING

If the frame does not move to the correct incline level,

see HOW TO CHANGE CONSOLE SETTINGS on

page 25 and calibrate the incline system.

HOW TO ADJUST THE LEFT CRANK ARM

If the Left Crank Arm (21) feels loose while you are

pedaling, tighten the two M6 x 25mm Screws (96).

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, first unplug the power

cord. Next, remove the M6 Crank Screw (15), and

loosen the two M6 x 25mm Screws (96) in the Left

Crank Arm (21). Then, slide the Left Crank Arm off the

studio cycle.

MAINTENANCE AND TROUBLESHOOTING