Operation Manual

Next, remove all of the Screws (not shown) attach-

ing the Right and Left Shields (30, 32); make sure

to remember where the two shortest Screws are

located. Then, move the Left Shield out of the way

until you can reach the Reed Switch (115).

Slightly loosen the two M4 x 16mm Screws (83). Next,

rotate the Right Crank Arm (not shown) until a Pulley

Magnet (137) is aligned with the Reed Switch (115).

Slide the Reed Switch slightly toward or away from the

Pulley Magnet. Then, retighten the Screws.

Plug in the power cord and rotate the Right Crank Arm

(not shown) for a moment. Repeat these actions until

the console displays correct feedback.

When the reed switch is correctly adjusted, reattach

the right and left shields and the left crank arm.

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

setting, the drive belt may need to be adjusted.

To adjust the drive belt, first unplug the power cord.

Then, follow the instructions at the right. Note: The

drawings show only the right side of the studio cycle.

Remove the indicated M4 x 16mm Screw (83) and the

Shield Cover (31) from each side of the studio cycle.

Next, loosen the M10 Axle Nut (27) on each side of

the studio cycle, and tighten the Adjustment Nut (26)

on each side of the studio cycle one half turn. Then,

firmly retighten the M10 Axle Nuts.

Plug in the power cord and pedal the studio cycle to

test the adjustment. If necessary, repeat the above

actions until the pedals no longer slip.

When the drive belt is properly adjusted, reattach the

shield covers.

115

30, 32

137