Installation Guide
14
Step
Installation Procedure(ex. @Garage)
Necessary Tool
10 Take off the existing rain cap and place it on the area where it does not fall from the rooftop.
Make sure the inside surfaces of the "④B-Vent" are clean to ensure a good seal of the parts in this step.
Wet Towel
11
Use a marker to mark the original position of the "
③
Flex Pipe 2"", at "
④
B-Vent"'s upper tip.
Marker
12
Slide-in the
"
②
Top Flex Support"
to the
"③Flex Pipe 2"".
Top Flex support
Mark is very important for the function. Do not skip this step.
(Necessary for the next step.)
Be sure to do
Inert the
"
②
Top Flex Support"
's slit straight into the Flex Pipe groove.
Be sure to do
Step-2
Slide-in
Pull up
Mark
Verify that you can see the mark you made at the top end of the "
②
Top
Flex Support" in the previous step.
Be sure to do