Installation Guide
18
Step
Installation Procedure(ex. @Garage)
Necessary Tool
Step-3
(Work where equipment is installed)
Point
When performing the final cut, make the first cut of the "③Flex Pipe 2"" longer to
avoid cutting the "③Flex Pipe 2"" too short. It is easy to determine the length by
following the Pointbelow and matching the dimension using the below figure.
Point
When determining the cut length, take note on the 2 points listed below.
Point
Determine the proper length not giving too much tension to both
"
⑥
Base Junction Support
"
and
"
⑧Rigid 45 Elbow Set".
Correct installation Incorrect installation
When the vent pipe is too short,
there will be tension to those
parts.
Point
Be careful not make trap configuration of "
③
Flex pipe 2"".
Correct installation Incorrect installation
In trap installation, moisture is
trapped inside the vent pipe and
the exhaust can't be vented.