Installation Guide

19
Step Installation Procedure(ex. @Garage)
Necessary Tool
18
Pull " ⑦Flex Sleeve " over " ③Flex Pipe 2" " under the ceiling. Then, push into the bottom of
" ⑥Base Junction Support " . And check that " ③Flex Pipe 2" " is sticking out from " ⑦Flex
Sleeve " . (If it is not sticking out,cut " ⑦Flex Sleeve " until " ③Flex Pipe 2" " sticks out.)
󰴪Flex Sleeve
 Do not extend the "⑦Flex Sleeve" if it needs to be cut, it should be cut while in its
compressed state.
19
Firmly tighten "⑥B. Flex Sleeve Clamp" of "⑥Base Junction Support", but be careful
not to tighten too much as it may distort the "⑦Flex Sleeve" and rubber. Check to see if
it is firmly fixed by pulling it by hand.
The tightening torque shall be between 7 and 10 in lb.
Step-3
(Work where equipment is installed)
Pay attention not to get injured from the sharp edge of "⑦Flex Sleeve".
WARNING
OK
NG
Flat head
Screwdriver
Box wrench
(5/16")
or
Point
"
③ Flex Pipe 2"" not visible.
Point
"
③ Flex Pipe 2"" is visible.