Installation Guide
20
Step
Installation Procedure(ex. @Garage)
Necessary Tool
20
See below chart and set "⑨Flex Vent 2" Gasket" onto the tip of "③Flex Pipe 2"".
Flex Vent 2" Gasket
21
Pull out "⑧Rigid 45 Elbow Set", which are tentatively locked to the equipment's vent connector pipe.
Insert the "③Flex Pipe 2"" from the previous procedure into the "⑧Rigid 45 Elbow Set".
Rigid 45 Elbow Set
Step-3
(Work where equipment is installed)
Make sure the "③Flex Pipe 2"" is fully secure by checking the
bottom(reverse side) of the "⑧Rigid 45 Elbow Set" when you are
finished.
Be sure to do
Point
Correct way of setting "⑨Flex Vent 2" Gasket".
Vent
Connector
Pipe