Installation Guide

22
Step Installation Procedure(ex. @Garage)
Necessary Tool
26
Extend the lower end of "⑦Flex Sleeve" to the sleeve clamp connector of the upper
portion of equipment.
Then secure with "2×⑩Fastening Screws", and apply "⑪Aluminum tape" covering the
connecting part. Make sure that it is firmly fixed by pulling by hand.
Do not stretch the "⑦Flex Sleeve" where the screws are secured, it will weaken the
point where the screws are attached to the "⑦Flex Sleeve".
Phillips head
Screwdriver
󰴭Fastening Screws
󰴮Aluminum tape
Step-3
(Work where equipment is installed)
Pay attention not to get injured from the sharp edge of "⑦Flex Sleeve"
WARNING
Point
Check and see if "⑦Flex Sleeve" is firmly fixed.
7.Maintenance
 The venting system must be examined periodically by a qualified service technician to check for any leaks
or corrosion.
 Check and confirm that there is no tension to the flexible vent by hanging or suspending of anything.
 When changing the water heater, change whole venting components to new ones.
Periodically check the following to ensure proper
operation of the water heater.
45°
45°
Sleeve Clamp
<EZTR40>
<EZTR50 75>
Connector
Point
Screw locations are within
these two degree.