Installation Guide

C
LEAN FUNCTION
N
O
TE: ALWAYS empty the ice bin and make sure there is no ice on the evaporator before running the cleaning function.
NOTE:
ALWAYS clean and sterilize the ice bin, ice sliding board, water distribution pipe, water supply pipe, an
d water pump, then rinse completely.
• Turn on the ice maker and push the “Clean” button for 3 seconds. Put the proper amount of commercial ice maker cleaning or descaling
solution into the water trough manually per the products instructions, let it sit there for about 1 minute, then push the 'Clean' button
again. The ice maker will enter the cleaning process and will run an auto clean cycle for about 15 minutes. Spray the evaporator with some
solution while this is running to ensure complete cleaning. When finished, the “Clean” LED will flash slowly.
• Manually put sterilization solution into the water trough per the product instructions and press the “Clean” button again. The process will
run about 15 minutes. Be sure to spray some of the solution onto the evaporator while this is running to ensure complete sterilization.
• When sterilization is complete, the unit will enter a rinsing cycle that lasts about 5 minutes. This will repeat 5 times.
• When the entire cleaning cycle is complete, the unit will go back into the ice making mode. Allow it to make 5 batches of ice, and be sure
to dispose of these first 5 batches after cleaning. It is recommended that the ice maker be cleaned and maintained at least every 4 weeks.
Failure to do so may result in the unit malfunctioning. The maintenance of the ice machine or malfunctions due to improper maintenance
are not covered by the manufacturer's warranty.
Put cleaner in front right side
of tank
Cleaners are discharged from
the outlet
NOTE: Be sure to use a sterilization solution specifically meant for commercial ice makers
13