User Guide

118 Chapter 4 Configuring the domain
320818-A
A Nortel SNAS 4050 domain encompasses all the switches, authentication
servers, and remediation servers associated with that Nortel SNAS 4050 cluster.
If you ran the quick setup wizard during initial setup, Domain 1 has been created.
If you did not run the quick setup wizard, you must create at least one domain. For
information about creating a domain, see “Creating a domain using the CLI” on
page 121 or “Creating a domain using the SREM” on page 151.
To delete a domain, see “Deleting a domain using the CLI” on page 129 or
“Deleting a domain using the SREM” on page 163.
Configuring the domain using the CLI
To configure the domain, access the Domain menu by using the following
command:
/cfg/domain
From the Domain menu, you can configure and manage the following:
• domain parameters such as name and portal IP address (pVIP) (see
“Configuring domain parameters using the CLI” on page 130)
• Authentication, Authorization, and Accounting (AAA) features
• for authentication, see “Configuring authentication” on page 233
• for authorization, see “Configuring groups and profiles” on page 191 and
“Configuring the TunnelGuard check using the CLI” on page 132
• for accounting, see “Configuring RADIUS accounting using the CLI” on
page 146
• the SSL server used for the domain portal (see “Configuring the SSL server
using the CLI” on page 135)
• SSL trace commands
• SSL settings
Note: With Nortel Secure Network Access Switch
Software Release 1.0, you cannot configure the Nortel SNA solution to
have more than one domain.