User Guide

Chapter 4 Configuring the domain 127
Nortel Secure Network Access Switch 4050 User Guide
11 To add a network access device, enter the required information when
prompted. For more information, see “Using the quick switch setup wizard”
on page 75.
To continue, go to step 12.
12 Specify the action to be performed when an SRS rule check fails. The options
are:
•
restricted — the session remains intact, but access is restricted in
accordance with the rights specified in the access rules for the group
•
teardown — the SSL session is torn down
The default is
restricted.
13 Specify whether you want to create a test user (
tg) in the default
tunnelguard group.
If you do want to create a test user, press Enter to accept the default value
(
yes). The wizard will create a test user named tg, with password tg, in the
default
tunnelguard group.
If you do not want to create a test user, enter
no.
14 Wait while the wizard completes processing to create the domain, then enter
Apply to activate the changes.
Do you want to configure a switch? (yes/no) [no]: yes
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]:
IP address of Switch:
NSNA communication port[5000]:
Red vlan id of Switch:
In the event that the TunnelGuard checks fails on a
client, the session can be teardown, or left in
restricted mode with limited access.
Which action do you want to use for TunnelGuard failure?
(teardown/restricted) [restricted]:
Do you want to create a tunnelguard test user? (yes/no)
[yes]: