User Guide

Chapter 4 Configuring the domain 139
Nortel Secure Network Access Switch 4050 User Guide
Configuring SSL settings using the CLI
To configure SSL-specific settings for the portal server, use the following
command:
/cfg/domain #/server/ssl
The SSL Settings menu displays.
dnslookup <host>
Finds the IP address for a machine whose host name
you specify, or the host name of a machine whose IP
address you specify.
•
host is the host name or IP address of the
machine
If a backend interface is mapped to the current Nortel
SNAS 4050 domain, the check is made through the
backend interface. To map a backend interface to the
domain, use the
/cfg/domain #/adv/interface command
(see “Configuring advanced settings using the CLI” on
page 145).
traceroute <host>
Identifies the route used for station-to-station
connectivity across the network.
•
host is the host name or IP address of the target
station
If a backend interface is mapped to the current Nortel
SNAS 4050 domain, the check is made through the
backend interface. To map a backend interface to the
domain, use the
/cfg/domain #/adv/interface command
(see “Configuring advanced settings using the CLI” on
page 145).
To be able to use a host name, the DNS parameters
must be configured (see “Configuring DNS servers and
settings using the CLI” on page 477).
/cfg/domain #/server/trace
followed by: