User Guide

Chapter 4 Configuring the domain 143
Nortel Secure Network Access Switch 4050 User Guide
To set up a syslog server to receive UDP syslog messages for all HTTP requests
handled by the portal server, use the following command:
/cfg/domain #/server/adv/traflog
The Traffic Log Settings menu displays.
The Traffic Log Settings menu includes the following options:
/cfg/domain #/server/adv/traflog
followed by:
sysloghost <IPaddr>
Specifies the IP address of the syslog server.
udpport <port>
Specifies the UDP port number of the syslog server.
• port is an integer in the range 1–65534 that
indicates the UDP port number. The default is 514.
protocol
ssl2|ssl3|ssl23|tls1
Specifies the protocol to use when establishing an SSL
session with a client. Valid options are:
•
ssl2 — accept SSL 2.0 only
•
ssl3 — accept SSL 3.0 and TLS 1.0
• ssl23 — accept SSL 2.0, SSL 3.0, and TLS 1.0
•
tls1 — accept TLS 1.0 only
The default value is
ssl3.
priority debug|info|
notice
Specifies the priority level of the syslog messages that
are sent. Valid options are:
• debug — information useful for debugging
purposes only
•
info — informational messages
•
notice — information about conditions that are
not error conditions but nevertheless warrant
special attention
The default value is
info.
facility
auth|authpriv|daemon|
local0-7
Sets the facility parameter of syslog messages. The
facility parameter specifies the type of program logging
the message. The configuration file can then specify
different handling for messages from different facilities.
The default value is local4.
ena
Enables traffic logging with syslog messages to the
specified syslog server.
Traffic logging with syslog messages is disabled by
default.