User Guide

Chapter 5 Configuring groups and profiles 199
Nortel Secure Network Access Switch 4050 User Guide
• number of sessions — the maximum number of simultaneous portal or Nortel
SNAS 4050 sessions allowed for each member of the group. The default is
0 (unlimited). You can later modify the number of sessions by using the
restrict command on the Group menu.
The Group menu displays.
The
Group menu includes the following options:
Note: If you ran the quick setup wizard during initial setup, a group
called
tunnelguard has been created with group ID = 1.
/cfg/domain 1/aaa/group #
followed by:
name <name>
Names or renames the group. After you have defined a
name for the group, you can use either the group name
or the group ID to access the Group menu.
•
name is a string that must be unique in the domain.
The maximum length of the string is 255
characters.
The group name must match a group name used by the
authentication services. For more information, see
Table 30 on page 196.
restrict
Sets the maximum number of simultaneous portal or
Nortel SNAS 4050 sessions allowed for each member
of the group.
For example, if the value is set to 2, then a user can
use two computers at the same time and have two
simultaneous sessions running. The default is 0
(unlimited).
linkset
Accesses the Linksets menu, in order to map
preconfigured linksets to the group (see “Mapping
linksets to a group or profile using the CLI” on
page 206).
For information about creating and configuring the
linksets, see “Configuring linksets using the CLI” on
page 411.
extend <profile ID>
Accesses the Extended Profiles menu, in order to
configure extended profiles for the group (see
“Configuring extended profiles using the CLI” on
page 203).
To view existing profiles, press TAB following the
extend command.