User Guide

Chapter 5 Configuring groups and profiles 201
Nortel Secure Network Access Switch 4050 User Guide
Configuring client filters using the CLI
To create and configure a client filter, use the following command:
/cfg/domain 1/aaa/filter <filter ID>
where filter ID is an integer in the range 1 to 63 that uniquely identifies the
filter in the Nortel SNAS 4050 domain.
When you first create the filter, you must enter the filter ID. After you have
created the filter, you can use either the ID or the name to access the filter for
configuration.
When you first create the filter, you are prompted to enter the client filter name.
The Client Filter menu displays.
Note: If you ran the quick setup wizard during initial setup, two client
filters have been created:
tg_passed (filter ID = 1) and tg_failed
(filter ID = 2).